Vanagon 1983-1984

Bosch Number
0237 022 025
VW Number
025 905 205D
Remarks
1900 Digijet
Rotor
04 038
Dust Cover
039-905-241, Bosch 1230 500 139 > 1230 500 147
Cap
03 010 Note: If equipped with Ignition Wires with Suppressors at Both Ends (Bosch 09 272), use 03 212
Distributor Cap Clip
034-905-265, Bosch 1231 251 033
Parts Kit (Shims, Washers & Hardware)
059-998-211, Bosch 1237 010 007
Coil
00 041
Ignition Wires
If using 03 010 Cap: 09 180, if using 03 212 Cap: 09 272
Vacuum Can
07 212
Spark Plug
W7CC, WR7DTC
Timing Set At
5deg ATDC @ 850 rpm w/strobe, vacuum hose(s) connected. Idle Stabilizer must be disconnected and it's plugs directly connected together (bypassing the Stabilizer) for accurate timing with strobe. Reconnect.
Advance/Retard Range
Vacuum: 12-16deg Adv @ 10.6 In. Hg, 9-11deg Ret @ 10.6 In. Hg; Centrifugal: 16-20deg @ 2400 rpm, 21-25deg @ 3800 rpm

Dist Hall Sender w/Parts: 035-998-065, Bosch 1237 011 050

Ignition Control Module (On Left Firewall): VW 211-905-351B or D, Bosch 0227 100 137

(Note: VW has superseded this to 191-905-351B, Bosch 0227 100 142. This unit is supposed to be heavier duty, mounted onto it's own cast iron heat sink, which is in turn mounted to the existing heat sink on the left firewall. Longer sheet metal screws will be needed when performing this superseded installation.)

Note: Will replace OE Fairchild/Telefunken Module if installed

Internal Distributor Parts:

Hall Impulse Generator: 035-905-315 1237 031 053 > 1237 031 061

(Note: Very expensive by itself - cheaper to buy Hall Sender w/Parts above) 

Timing Core/Rotor (Reluctor): 071-905-309A, 1231 328 032 > 049-905-309A, 1231 328 046

Pin for Reluctor: 035-905-319, 1233 101 035

Coned Spring Washer for Reluctor: 035-905-321, 1230 150 004

"C" Lock Ring for Reluctor (2 Req'd): 035-905-323, 1230 118 002

Black Plastic Hall Connector on side of Distributor: 035-905-331, 1230 329 009